Why did the chimney break in one third when it was blasted?
Because the acceleration at the bottom end is not the same as the acceleration at the top end during the process of the chimney falling down, the middle part of the chimney is bent when the chimney falls down. Chimney blasting is to blast the root on one side of the design collapse direction, and leave the other side unblasted. After blasting, part of the cylinder wall of the blasting gap is blasted away, and the section of the unexploded part is under the action of gravity bending moment. The medium is damaged by compression, and the medium on the other side is damaged by tension. Due to the reduction of the bearing area of the support section, this tension-compression failure process develops rapidly like an avalanche, resulting in the section that retains the unexploded part completely losing its bearing capacity and support. ability. In this way, the upper part of the chimney acts like a rigid rod under gravity and rotates in the plane where its center of gravity lies.
