Dec 07, 2020

Problems and treatment of flue gas desulfurization system in power plant

Leave a message

The desulfurization baffle door often has some titles in the actual production operation. The second is that the liquid level of the suction tower is not as good as the actual reaction. The actual liquid level of the suction tower, the failure of the oxidation fan and the settlement difference, the failure of the limestone slurry preparation system The powder is not smooth, the vacuum belt conveyor has tripped due to the deviation of the filter cloth from the left and right, the suction tower demister has a large amount of talk, which causes the leakage of the net flue gas flue contraction joint and the GGH low leakage fan volute and impeller fouling, vacuum The plaster cake flushing water tank of the belt conveyor accumulates gypsum, which causes the gypsum cake flushing water pump to be unable to be put into operation normally. The wet desulfurization system is located behind the induced draft fan of the steam boiler. The desulfurization system and the main engine system were rejected for simultaneous construction. Therefore, the desulfurization system did not add a booster fan and the move to increase the induced draft fan of the boiler was rejected. Surrender, so the blower capacity needs to be increased. Because the flue gas is directly connected, the flue gas baffle desulfurization system is put into operation and shut down, and the starting and stopping of the suction tower slurry circulation pump has a greater impact on the negative pressure of the steam boiler chamber, especially when the boiler load is low and the volatile content is low. It may cause the boiler to stall.

The fouling and accumulation in the FGD system will cause the pipeline to block, wear, succeed, and reduce the system resistance, which should be minimized. During operation, the following aspects can be used to alert the generation of scaling:

1) Advance the durability and reliability of the electric precipitator for steam boilers, so that the FGD inlet smoke and dust are within the scope of planning.

2) Operation control The supersaturation of gypsum in the slurry of the suction tower does not exceed 140%.

3) Choose a smooth pH operation. The flue gas damper door especially instills a sharp change in pH.

4) Ensure the surplus oxidation of the suction tower slurry.

5) The pipeline for the war slurry should be cleaned in time when it is out of service.

In addition, there must be a complete monitoring system plan. The monitoring of the flower chamber mainly includes: the amount of flue gas processed, the SO2 concentration at the inlet of the desulfurization equipment, the inlet of the desulfurization equipment and the inlet flue gas temperature (according to whether there is GGH, the inlet flue gas temperature monitoring is set at GGH The inlet outlines the suction tower inlet), the pH value of the liquid in the suction tower and the flower chambers that must be monitored in order to ensure safety, such as the inlet pressure of the dust removal tower/suction tower circulating pump, the desulfurization flue gas baffle door, and the flow in the circulation pipe, desulfurization equipment The pressure of each ventilation system, etc.


Send Inquiry