Oct 17, 2022

Motion System Options for HVAC Gas Valve Actuators

Leave a message

In HVAC systems that provide heat to enclosed spaces, sensing and regulating elements such as flow control valves or isolation valves must be used to accurately control and meter the flow of gases and liquids. While some control valves are manually opened and closed on the valve stem, electronic valves contain an actuator that moves the valve stem through the control of a motor and drive system. Designers can choose from three motor types based on application requirements. Below is a summary of the motion system options:


Brushed DC motors for rotary motion, or linear motion with external lead screw. This simple DC motor does not require complex electronics to drive the motor. However, if the application requires linear motion, the DC motor will require an additional lead screw and gear system to convert rotational motion to linear motion. It also requires a feedback mechanism, such as an optical sensor or encoder, for precise linear position control.


DC stepper motors are used for rotary motion, or linear motion with an external lead screw. Stepper motors rotate in several small, equal and discrete increments, called stepping, and the drive requires a dedicated control unit. Due to the discrete steps that provide built-in positioning control, the motor can operate with good accuracy in open loop if properly sized. It is also designed to use braking torque to provide holding position, and the motor provides excellent response for starting, stopping and reversing operations. If linear motion is required, an additional lead screw and gear drive system is required to convert rotational motion to linear motion. Typically, stepper motors can provide output speeds of up to 1,000 rpm and torques of up to 170 millinewton meters. Actual torque and speed also depend on whether the drive mode is full, half, or microstepping.


Stepping linear actuator with integrated lead screw. This compact device combines a pot-type stepper motor with a threaded rotor and an integrated lead screw to provide direct linear motion. When an electrical pulse is applied, the stepper linear actuator lead screw moves up and down in discrete step increments. Because the stepper linear actuator can be precisely controlled in an open loop system, no expensive feedback devices or braking systems are required for positioning. Typically, linear actuators can provide output speeds of up to 80 mm per second and provide forces of up to 100 Newtons. Actual force and speed also depend on lead screw efficiency and drive mode - full, half or microstepping.




Key Considerations for Motor Selection

When choosing a motor, keep the following considerations in mind:


• Required maximum and operating torque and force

• Speed Requirements: Typically, valve applications require force and torque at low speeds.

• Total system price

• Control system: Closed-loop control is usually not required.

• Type of motion required for the drive: rotary or linear

• Expected life of the system before replacement

• Desired linear or rotational resolution

• Maximum current and voltage available

Depending on the motion options available and HVAC requirements, stepper motors are ideal for rotary applications, while linear stepper motors are more suitable for linear applications.


Send Inquiry